Hi,
ich hab hier 4.3 -STABLE auf CUBX-E laufen. Und habe auch
kleine Probleme. Erstens P-III 800Mhz funkzt nicht auf diesem board
mit dieser Frequenz. Das liegt daran dass CUBX-E 133FSB nicht
unterstuezt. Beim booten nach der Erkennung, atapci1:
<Promise ATA100 controller>, und nach fd0: <1440-KB 3.5" drive> on
fdc0 drive, kommt jedes mal Pause ~20-40 sek., was nicht besonderes
angenehm ist. Aber mit read/write (mit softupdates) habe ich
ueberhaupt keine Probleme. Ich hab IBM-DTLA-307030 und bin damit
zufrieden. Ich vermute bei dir liegt es an Matrox Festplatten.
-- Kirill Ponomarew On Sat, May 19, 2001 at 07:01:14PM +0200, Hendrik Scholz wrote: > Moin Moin! > > Ich habe hier eine Kiste mit FreeBSD 4.3-STABLE auf einem > ASUS CUBX-E (mit Promise UDMA 100 onboard) laufen: > > [...] > atapci1: <Promise ATA100 controller> port 0xa800-0xa83f,0xb000-0xb003,0xb400-0xb407,0xb800-0xb803,0xd000-0xd007 mem 0xc4800000-0xc481ffff irq 10 at device 7.0 on pci0 > ata2: at 0xd000 on atapci1 > ata3: at 0xb400 on atapci1 > [...] > ad4: 39083MB <Maxtor 94098H6> [79408/16/63] at ata2-master UDMA100 > ad5: 58623MB <Maxtor 96147U8> [119108/16/63] at ata2-slave UDMA100 > ad6: 78167MB <Maxtor 98196H8> [158816/16/63] at ata3-master UDMA100 > ad7: 39266MB <IBM-DTLA-305040> [79780/16/63] at ata3-slave UDMA100 > acd0: DVD-ROM <DVS DVD-ROM DSR-520H 990909A0> at ata0-master using PIO4 > [...] > > Wenn ich etwas auf der Platte entpacke oder einfach nur viel auf der > Platte mache, dann steht das System nahezu komplett. Selbst fuer das > Abspielen von MP3's reicht es nicht mehr. > > hscholz(at)dionysus:~ > dd if=/dev/zero of=testfile > ^C538463+0 records in > 538462+0 records out > 275692544 bytes transferred in 39.268626 secs (7020682 bytes/sec) > hscholz(at)dionysus:~ > > > Von UDMA100 haette ich etwas mehr erwartet. > > Gibt es Tuning-Moeglichkeiten ? > > Danke, Hendrik To Unsubscribe: send mail to majordomo(at)de.FreeBSD.org with "unsubscribe de-bsd-questions" in the body of the messageReceived on Sun 20 May 2001 - 01:39:19 CEST