ata0-slave doesn't show up!

Hi!

I installed FreeBSD-4.1-RELEASE yesterday. Right afterwards I cvsuped to
4.1-STABLE and built the system and a new kernel following the steps in
UPDATING.
The system runs fine, but I have one single problem: ata0-slave doesn't
show up when booting the new kernel although it does when I boot the
kernel that comes with 4.1-RELEASE.

dmesg output when booting the 4.1-RELEASE-kernel:

----------
atapci0: <AcerLabs Aladdin ATA33 controller> port 0xb800-0xb80f irq 0 at
device 15.0 on pci0
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
ad0: 19536MB <ST320423A> [39693/16/63] at ata0-master using UDMA33
ad1: 19536MB <ST320423A> [39693/16/63] at ata0-slave using UDMA33
ata1-master: DMA limitted to UDMA33, non-ATA66 compliant cable
ad2: 14664MB <IBM-DJNA-351520> [29795/16/63] at ata1-master using UDMA33
acd0: CDROM <ASUS CD-S500/A> at ata1-slave using PIO4
-----------

But every kernel I build from the 4.1-STABLE sources (as well the
GENERIC) results in the following result:

-----------
atapci0: <AcerLabs Aladdin ATA33 controller> port 0xb800-0xb80f irq 0 at
device 15.0 on pci0
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
ad0: 19536MB <ST320423A> [39693/16/63] at ata0-master using UDMA33
ata1-master: DMA limited to UDMA33, non-ATA66 compliant cable
ad2: 14664MB <IBM-DJNA-351520> [29795/16/63] at ata1-master using UDMA33
acd0: CDROM <ASUS CD-S500/A> at ata1-slave using PIO4
-------------

Where is ad1? I don't have any idea what's wrong. I tried a lot of
kernel-configs, but I can't make ata0-slave show up.

I tried it with the following entries in my kernel-config:

example I:

device ata0
device ata1
device ata
device atadisk
device atapicd
options ATA_STATIC_ID

example II:

device ata
device atadisk0
device atadisk1
device atapicd
options ATA_STATIC_ID

example III (from the 4.1-STABLE-GENERIC):

device ata0 at isa? port IO_WD1 irq 14
device ata1 at isa? port IO_WD2 irq 15
device ata
device atadisk # ATA disk drives
device atapicd # ATAPI CDROM drives
options ATA_STATIC_ID

What am I missing? I hope anybody can help me out! Thanks a lot for your
attention and your help!

Best Regards,
Herbert

To Unsubscribe: send mail to majordomo(at)de.FreeBSD.org
with "unsubscribe de-bsd-questions" in the body of the message
Received on Sun 27 Aug 2000 - 12:02:59 CEST