Thinkpad 770ED Boot/installation problem

Guckux

Has anyone experiences with installing FreeBSD on a IBM Thinkpad 770ED?
My machine has following configuration:
TP 770ED, 7.8GB IBM DYLA-HD (78100?), 96MB Ram, iPII-266, Trident-Video.
PCMCIA: PSION DACOM 56Kflex/fax/ISDN
        3COM 3C589D

Does not matter, if cards inserted or not.

Experiences:
- Booting with FreeBSD 2.2.7 RELEASE CD-Rom:
        hangs while kernel config
Booting with FreeBSD 3.1 RELEASE CD-Rom:
        takes a long time to boot
        after kernel was booted, no access possible (Device not configured)

the machine hangs with a few fast short "deep" "pieps". Sometimes while in
the kernel configuration kernel menu, sometimes while checking the
devices.

Booting with FreeBSD 3.4PAO Diskettes:
        boots pretty good, kernel configuration OK
        quitting the configuration menu and booting the kernel:
        it hangs with a few fast short "deep" pieps

here are the last output lines from the PAO-Boot:
---------- cut ---------
avail memory = 9147872 (89328K bytes)
Preloaded elf kernel "kernel" at 0xc061b000
Preloaded mfs_root "/mfsroot" at 0xc061b09c
Pentium Pro MTRR support enabled
chip0: <Intel 82443BX host to PCI bridge (AGP disabled)> rev 0x02 on pci0.0.0
pcic0: <TI PCI-1250 PCI-CardBus Bridge> rev 0x02 int a irq 255 on pci0.2.0
TI12XX PCI Config Reg: [ring enable][speaker enable][pwr save][CSC parallel isa
irq]
pcic1: <TI PCI-1250 PCI-CardBus Bridge> rev 0x02 int b irq 255 on pci0.2.1
TI12XX PCI Config Reg: [ring enable][speaker enable][pwr save][CSC parallel isa
irq]
vga0: <Trident model 9397 VGA-compatible display device> rev 0xf3 int a
irq 11 on pci0.3.0
chip1: <Intel 82371AB PCI to ISA bridge> rev 0x01 on pci0.7.0
ide_pci0: <Intel PIIX4 Bus-Master IDE controller> rev 0x01 on pci0.7.1
chip2: <Intel 82371AB Power management controller> rev 0x01 on pci0.7.3
Probing for devices on PCI bus 1:
Probing for devices on PCI bus 2:
Probing for devices on PCI bus 3:
Probing for devices on PCI bus 4:
Probing for devices on PCI bus 5:
Probing for devices on PCI bus 6:
Probing for PnP devices:
>>> HANGS (the machine is frozen)
--------------- cut -------------

any ideas? It seems, the PnP stuff makes the problem?!

Bye
     Stefan

To Unsubscribe: send mail to majordomo(at)de.FreeBSD.org
with "unsubscribe de-bsd-questions" in the body of the message
Received on Sun 09 Apr 2000 - 20:22:27 CEST