Konfiguration wlan Karte

Hi Liste,

Ich hab mir jetzt eine Wlan karte zugelegt D-Link DWL-650+

Laut man wi sollte die laufen, machts aber nicht. Koennte es eventuell an dem
"+" hinter 650 liegen?

eintrag in meiner /etc/defaults/pccard.conf:
# DLink DWL-650 11Mbps WLAN Card
card "D-Link" "DWL-650 11Mbps WLAN Card"
        config auto "wi" ?
        insert /etc/pccard_ether $device start
        remove /etc/pccard_ether $device stop

in der bootmessage wird aber leider kein wi eingerichtet. Ich hatte vorher eine
Wlan karte von Lucent technologies drin, und die wurde gleich beim ersten start
erkannt.

ifconfig gibts auch nix interessantes her:
fxp0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
        inet6 fe80::200:eff:fe21:a026%fxp0 prefixlen 64 scopeid 0x1
        inet 0.0.0.0 netmask 0xff000000 broadcast 255.255.255.255
        ether 00:00:0e:21:a0:26
        media: Ethernet autoselect (none)
        status: no carrier
lp0: flags=8810<POINTOPOINT,SIMPLEX,MULTICAST> mtu 1500
lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> mtu 16384
        inet6 ::1 prefixlen 128
        inet6 fe80::1%lo0 prefixlen 64 scopeid 0x3
        inet 127.0.0.1 netmask 0xff000000

Anbei noch meine dmesg -a
Ich glaub interessant sind folgende Zeilen, die mich aber bei der
Problemloesung nicht weitergebracht hatten:

----8<----
cardbus0: Resource not specified in CIS: id=10, size=20
cardbus0: Resource not specified in CIS: id=18, size=10000
cardbus0: <network> at device 0.0 (no driver attached)
cbb0: CardBus card activation failed
---->8----

dmesg -a:
Copyright (c) 1992-2003 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
        The Regents of the University of California. All rights reserved.
FreeBSD 5.1-RELEASE #0: Fri Nov 21 18:52:31 GMT 2003
    root(at)lifebook.heimnetz.mme:/usr/src/sys/i386/compile/MYSOUND
Preloaded elf kernel "/boot/kernel/kernel" at 0xc073f000.
Preloaded elf module "/boot/kernel/acpi.ko" at 0xc073f244.
Timecounter "i8254" frequency 1193182 Hz
Timecounter "TSC" frequency 597071156 Hz
CPU: Intel Pentium III (597.07-MHz 686-class CPU)
  Origin = "GenuineIntel" Id = 0x686 Stepping = 6
  Features=0x383f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR,SSE>
real memory = 134217728 (128 MB)
avail memory = 122482688 (116 MB)
Pentium Pro MTRR support enabled
npx0: <math processor> on motherboard
npx0: INT 16 interface
acpi0: <FUJ THYME > on motherboard
pcibios: BIOS version 2.10
Using $PIR table, 5 entries at 0xc00fdf70
acpi0: power button is handled as a fixed feature programming model.
Timecounter "ACPI-fast" frequency 3579545 Hz
acpi_timer0: <24-bit timer at 3.579545MHz> port 0xff08-0xff0b on acpi0
acpi_cpu0: <CPU> port 0x530-0x537 on acpi0
pcib0: <ACPI Host-PCI bridge> port 0xcf8-0xcff on acpi0
pci0: <ACPI PCI bus> on pcib0
pcm0: <Intel 443MX> port 0x1400-0x143f,0x1000-0x10ff irq 9 at device 0.1 on
pci0
pcm0: <Yamaha YMF743 AC97 Codec>
pci0: <simple comms> at device 0.2 (no driver attached)
isab0: <PCI-ISA bridge> at device 7.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <Intel PIIX4 UDMA33 controller> port 0x1480-0x148f at device 7.1 on
pci0
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
uhci0: <Intel 82443MX USB controller> port 0x14a0-0x14bf irq 15 at device 7.2
on pci0
usb0: <Intel 82443MX USB controller> on uhci0
usb0: USB revision 1.0
uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
uhub0: device problem, disabling port 2
pci0: <bridge, PCI-unknown> at device 7.3 (no driver attached)
fxp0: <Intel 82557/8/9 EtherExpress Pro/100(B) Ethernet> port 0x1440-0x147f mem
0xfc000000-0xfc01ffff,0xfc020000-0xfc020fff irq 9 at device 18.0 on pci0
fxp0: Ethernet address 00:00:0e:21:a0:26
miibus0: <MII bus> on fxp0
inphy0: <i82555 10/100 media interface> on miibus0
inphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
cbb0: <O2Micro OZ6933 PCI-CardBus Bridge> irq 9 at device 19.0 on pci0
cardbus0: <CardBus bus> on cbb0
pccard0: <16-bit PCCard bus> on cbb0
cbb1: <O2Micro OZ6933 PCI-CardBus Bridge> irq 9 at device 19.1 on pci0
cardbus1: <CardBus bus> on cbb1
pccard1: <16-bit PCCard bus> on cbb1
pci0: <display, VGA> at device 20.0 (no driver attached)
acpi_button0: <Power Button> on acpi0
acpi_acad0: <AC adapter> on acpi0
acpi_cmbat0: <Control method Battery> on acpi0
acpi_cmbat1: <Control method Battery> on acpi0
acpi_lid0: <Control Method Lid Switch> on acpi0
atkbdc0: <Keyboard controller (i8042)> port 0x64,0x60 irq 1 on acpi0
atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
kbd0 at atkbd0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: model GlidePoint, device ID 0
acpi_ec0: <embedded controller> port 0x66,0x62 on acpi0
sio0 port 0x3f8-0x3ff irq 4 on acpi0
sio0: type 16550A
sio1 port 0x118-0x11f,0x2e8-0x2ef irq 3 drq 3 on acpi0
sio1: type 16550A
ppc0 port 0x778-0x77b,0x378-0x37f irq 7 on acpi0
ppc0: Generic chipset (EPP/NIBBLE) in COMPATIBLE mode
ppbus0: <Parallel port bus> on ppc0
plip0: <PLIP network interface> on ppbus0
lpt0: <Printer> on ppbus0
lpt0: Interrupt-driven port
ppi0: <Parallel I/O> on ppbus0
fdc0: <Enhanced floppy controller (i82077, NE72065 or clone)> port
0x3f7,0x3f0-0x3f5 irq 6 drq 2 on acpi0
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
orm0: <Option ROMs> at iomem 0xcf800-0xd07ff,0xc0000-0xcf7ff on isa0
pmtimer0 on isa0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
Timecounters tick every 10.000 msec
acpi_cpu: throttling enabled, 8 steps (100% to 12.5%), currently 100.0%
cardbus0: Resource not specified in CIS: id=10, size=20
cardbus0: Resource not specified in CIS: id=18, size=10000
cardbus0: <network> at device 0.0 (no driver attached)
cbb0: CardBus card activation failed
ad0: 19077MB <TOSHIBA MK2016GAP> [38760/16/63] at ata0-master UDMA33
acd0: DVD-ROM <MATSHITADVD-ROM SR-8175> at ata0-slave PIO4
Mounting root from ufs:/dev/ad0s3a
Loading configuration files.
Entropy harvesting:
 interrupts
 ethernet
 point_to_point
.
swapon: adding /dev/ad0s3b as swap device
Starting file system checks:
/dev/ad0s3a: FILESYSTEM CLEAN; SKIPPING CHECKS
/dev/ad0s3a: clean, 457460 free (284 frags, 57147 blocks, 0.1% fragmentation)
/dev/ad0s3d: FILESYSTEM CLEAN; SKIPPING CHECKS
/dev/ad0s3d: clean, 884508 free (196 frags, 110539 blocks, 0.0% fragmentation)
/dev/ad0s3f: FILESYSTEM CLEAN; SKIPPING CHECKS
/dev/ad0s3f: clean, 483285 free (21 frags, 60408 blocks, 0.0% fragmentation)
/dev/ad0s3g: FILESYSTEM CLEAN; SKIPPING CHECKS
/dev/ad0s3g: clean, 1866529 free (21801 frags, 230591 blocks, 0.7%
fragmentation)
/dev/ad0s3e: FILESYSTEM CLEAN; SKIPPING CHECKS
/dev/ad0s3e: clean, 482478 free (198 frags, 60285 blocks, 0.0% fragmentation)
Setting hostname: lifebook.heimnetz.mme.
lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> mtu 16384
        inet6 ::1 prefixlen 128
        inet6 fe80::1%lo0 prefixlen 64 scopeid 0x3
        inet 127.0.0.1 netmask 0xff000000
Starting dhclient.
Additional routing options:
.
hw.bus.devctl_disable:
0
 ->
1

Mounting NFS file systems:
.
Starting syslogd.
Feb 12 19:17:53 lifebook syslogd: kernel boot file is /boot/kernel/kernel
Starting rpcbind.
ELF ldconfig path: /usr/lib /usr/lib/compat /usr/X11R6/lib /usr/local/lib
a.out ldconfig path: /usr/lib/aout /usr/lib/compat/aout /usr/X11R6/lib/aout
NFS access cache time=2
Starting amd.
Starting usbd.
Starting local daemons:
.
Updating motd.
Configuring syscons:
 keymap
 keyrate
 blanktime
 screensaver
.
Starting sshd.
Starting sendmail.
Initial i386 initialization:
.
Additional ABI support:
 linux
.
Starting cron.
Local package initialization:
.
Additional TCP options:
.
Starting moused:
.
Starting background file system checks in 60 seconds.

Thu Feb 12 19:17:59 CET 2004
Feb 12 19:18:58 lifebook su: jerik to root on /dev/ttyp0

-- 
J. Erik Heinz
Mitarbeiter am Lehrstuhl fuer 
Entwicklung betrieblicher InformationsSysteme
Hermann-Wendel-Str.6
60486 Frankfurt am Main
Handy: 0163 337 37 45
Home: 069 770 63 597
Mail: jheinz(at)wiwi.uni-frankfurt.de
Web: www.decoplex.com 
To Unsubscribe: send mail to majordomo(at)de.FreeBSD.org
with "unsubscribe de-bsd-questions" in the body of the message