Hi,
ich würde gerne auf meinem Notebook 4.6 installieren.
Allerdings hängt die Installation nach der Kernelkonfiguration - nach
"Erkennung" von Modem und Soundkarte an pci0 bleibt der Bootvorgang
komplett hängen. Gibt's eine Möglichkeit, den PCI-Scan einzuschränken ?
"Kurze" Infos zu den Geräten (von Linux' lspci -vv):
00:1f.5 Multimedia audio controller: Intel Corp. 82801BA/BAM AC'97 Audio
(rev 03)
Subsystem: Toshiba America Info Systems: Unknown device ff00
Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 0
Interrupt: pin B routed to IRQ 10
Region 0: I/O ports at 1c00 [size=256]
Region 1: I/O ports at 1880 [size=64]
00:1f.6 Modem: Intel Corp. 82801BA/BAM AC'97 Modem (rev 03) (prog-if 00
[Generic])
Subsystem: Toshiba America Info Systems: Unknown device 0001
Control: I/O+ Mem- BusMaster- SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Interrupt: pin B routed to IRQ 10
Region 0: I/O ports at 2400 [size=256]
Region 1: I/O ports at 2000 [size=128]
Danke und Gruß
Björn
-- "The number of Unix installations has grown to ten, with more expected" [ The Unix programmers manual, 1972 ] To Unsubscribe: send mail to majordomo(at)de.FreeBSD.org with "unsubscribe de-bsd-questions" in the body of the messageReceived on Fri 28 Jun 2002 - 15:45:27 CEST